Install the mounting frame HTM-RM in the installation opening and clean off dirt and dust. Apply lubricant HTM-SM to the inner surfaces of the frame, and thoroughly lubricate all corners.
Assembly of HTM penetration in rectangular frames HTM-RM with press block HTM-PBM
1
2
Route all first-row cables through the frame section. Select NTM modules according to the installation plan, and select inserts according to the cable diameter.
3
Thoroughly lubricate the outer surfaces of the modules and matched inserts (Mount the plug modules together with the core).
4
Fill the sections of the mounting frame with transit modules with cables passing through them, separating adjacent horizontal rows of modules with base plates HTM-OP.
5
Install an HTM-OPF fixing base plate before the last row of modules, followed by an HTM-OP base plate. Move the plates apart within the frame.
6
Place the modules of the last row between the fixing base and base plates. Compress all components with the jack HTM-DMU or HTM-DM, and fix with the fixing base plate bolts HTM-OPF.
7
Place the HTM-PBM press block in the mounting position (distance from the press block body to the bolt head is 8...11 mm). Thoroughly lubricate the internal and external surfaces of the press block with HTM-SM lubricate. Orient the press block according to the markings: "FRAME OR MODULES THIS SIDE" and "STAYPLATE THIS SIDE"
8
Insert the press block into the frame section so that the stop lug on its underside fits into the recess in the base plate, and the top wall of the mounting frame fits into the stop recess on the top of the press block. Tighten the bolts alternately clockwise, 2-3 turns at a time, but not all the way to the stop.
9
Loosen the HTM-OPF bolts one by one to evenly distribute the sealed components. Tighten the press block bolts (no more than 20 Nm). Remove excess lubricant, and check the immobility of the cables in the transit modules.